5S on-site innovation and improvement of Chongqing

2022-08-09
  • Detail

Chongqing water pump: 5S on-site innovation and improvement of the plate warehouse

recently, in order to improve the efficiency of the production site and reduce the preparation time for operation, the blanking group area has been equipped with 4 ball machines and reciprocating regular meetings, on-site communication and testing, etc., and the regional members have concentrated their suggestions to improve the 5S of the plate warehouse with reference to the opinions of the technical department. Constrained by the site, the current storage mode of materials in the plate warehouse of the storage and transportation department is stacking and overstocking layer by layer, accounting for

recently, in order to improve the efficiency of the production site and reduce the operation preparation time, the blanking group area has concentrated the suggestions of regional members through regular meetings, on-site communication and tests, and referred to the opinions of the technical department to improve the 5S of the plate warehouse

constrained by the site, the current storage method of materials in the plate warehouse at the storage and transportation place is stacking and overstocking layer by layer, which covers a large area, causing great inconvenience to subsequent use. Each time it is used, it needs to be hoisted layer by layer, and the hoisted plates can only temporarily occupy the road

especially thin plates, which are easy to bend and scratch when hoisting, especially nuclear power gasket products, have requirements for surface finish, and blank protection is always a problem. If you rely on manpower, you can reduce folding and scratches, but the efficiency is low, and there are still potential safety hazards

therefore, it is difficult to achieve the expected effect by simply adjusting the internal structure of the storage and transportation department with a 1-arc end face perpendicular to the current direction of the central axis and tightening the cost expenditure. The blanking group designed and manufactured the shelf tooling for the vertical placement of thin plates, and adopted the claw type lifting sling, which avoided various shortcomings of stacking layer by layer, and the classification and identification are obvious, which is easy to distinguish, and greatly improved the production efficiency and site utilization. (storage and transportation department yanwenyan)

Copyright © 2011 JIN SHI